Canadian owned and operated · Shipping across North America · Low-GWP R-32

Replacing a PTAC or through-wall unit.

Swap an old PTAC, wall sleeve unit or through-wall air conditioner for a Compact-Aire heat pump, reusing the existing wall opening. Send us what's there now and we'll confirm the model, the connector and the fit.

HOW IT WORKS

Three steps from the old unit to a heat pump.

01 · TELL US WHAT'S THERE

Brand, model and opening size

The existing unit's nameplate, the size of the wall opening and the power at the outlet. A photo of each is often enough.

02 · WE MATCH THE FIT

Model and Sunvent connector

We recommend the Compact-Aire model for the room and power available, and size a Sunvent connector to the opening.

03 · INSTALL

Reuse the opening

The Sunvent louvre face fills the old opening outside, and its transition box connects to the heat pump's supply and exhaust inside. No structural work.

WHAT TO MEASURE

Five things that confirm the fit.

Measure one typical room. If openings differ across the building, list each size and how many of each.

  • Wall opening: the inside width and height of the existing sleeve or opening, in inches or millimetres.
  • Wall thickness: from the interior finish to the exterior face.
  • Existing unit: brand and model number from the nameplate, usually behind the front panel.
  • Power: the voltage, the receptacle type and the breaker size serving the unit.
  • Where the new unit goes: the wall space below or beside the opening, and whether the room has an exterior wall behind it.
CHOOSING A MODEL

Start with the power at the opening.

Ratings from each model's WAYSOS spec sheet, at standard rating conditions (95°F cooling, 47°F heating). Check the circuit against the MCA and MOP in the comparison table.

115/120V · STANDARD OUTLETCompact-Aire Pro (115/120V)10,000 BTU/h cooling, 9,000 BTU/h heating. Plugs into a standard grounded outlet. The 115V Compact-Aire HP is coming soon.Compact-Aire Pro →
208/230V · COLD CLIMATESPro 1K and Pro 2K10,000 BTU/h cooling, 9,000 BTU/h heating, with 1 kW or 2 kW electric heat alongside the heat pump. Heat pump heating rated down to 5°F (−15°C).Compact-Aire Pro →
208/230V · LARGER ROOMSCompact-Aire 3K and 1.4K11,800 BTU/h cooling, 10,900 BTU/h heating, with a 3 kW or 1.4 kW electric heater that runs instead of the compressor.Compact-Aire →
ANY OPENINGSunvent connectorMade to size for the existing opening, with an anodized aluminum louvre outside and a galvanized transition box inside.Sunvent connector →

Brand-by-brand cross-reference: we're compiling a list of common PTAC and wall sleeve sizes matched to Compact-Aire and Sunvent. Until it's published, send us the brand, model and opening size below and we'll confirm the match.

SEND YOUR DETAILS

Tell us what you're replacing.

Fill in what you know; the number of units is the only must. Photos of the nameplate and the opening help most. We'll reply with the recommended model, connector size and a quote.

Prefer email? sales@waysos.com · +1 604-401-0298